booth instructions

Booth and oven shipment and assembly procedure

If you ordered a booth and oven from us this is what it will look like when you unwrap the freight fig1

The top 2 panels are the back of the booth, the 2 pieces of long metal that look like a “z” are the back wall braces and filter holders , below that is the side walls of the booth .{there is a left and right , the side with the holes in it is made for the electrical outlet and should be put on the right side } When you take all these panels off the top of the oven you are now ready to remove the top of the booth from the inside of the oven,

You will need something to prop the door of the oven up against , at our shop we use a forklift but you can also use a short ladder or wood , DO NOT OPEN THE DOOR AND HAVE IT REST ON THE HINGES IT WILL DESTORT THE HINGES IN THIS POSITION fig 2

While removing the booth you can start assembly , start with 1 side panel , and install the lower back wall , then the other side panel , next put the top on the booth , you will need 2 guys to do this part , ounce you get the top put into place and bolted in , you can install the upper back wall , and then the air filter holder . all you will need to do then is bring the electrical outlet down to the side wall and bolt it into place , the bag filter goes in the top part of the booth and the cap gets screwed into place , you may need to use some duct tape or masking tape to close off any small gaps . {see fig3-6}

fig 1

fig2

fig 3

fig 4

fig 5